Monday, April 30, 2012
Manual Files »
Home »
Dodge
»
Dodge Neon QuickLIFT Installation Guide
advertisement:
Dodge Neon QuickLIFT Installation Guide
A. Place a piece of masking tape on the edge of the hood and the edge of the fender as shown to the right. This will be used to mark the centerlines of both the hood brackets and fender brackets.
B. Hook the tape measure over lower corner of hood – be sure to measure from the hood corner (above hinge). Place a mark at exactly 10-3/4? on the fender tape, and 22-1/2? on the hood tape (see table below for model years). Mark both sides the same way and verifies your measurement. These measurements are critical, take your time.
Download
advertisement:
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.