Sunday, June 3, 2012
1993 Bronco/evaporator case Assembly Worked/F-Series workshop manual
The evaporator evaporator case Assembly is sitting on the side of the motor from the dash panel attached. The case is a two-piece cast construction, a piece of which constitutes the core of a cover over the evaporator. An integral vacuum reservoir is part of the cover housing. This reservoir and the vacuum motor, who works on the door of the outside air/recirc, are connected through a check valve to a snake that engine vacuum delivers. The blower housing is an integral part of the evaporator case. It houses the blower motor and wheel assembly that to the case through a mounting flange attaches on the blower motor. The blower motor resistor Assembly is on the case with the thermal elements to expand into the airflow within the evaporator case linked. The suction accumulator/drier is linked to the evaporator core by a bracket support.
Evaporator case Assembly, disassembled view Plenum Assembly plenum assembly is mounted to the dash panel in the passenger compartment. It contains the core heater, temperature blend door, door and the floor/defrost timer door. The temperature blend door is cable checked by means of a cam located at the top of the plenum. The Panel and floor/defrost doors are both controlled by vacuum motors, located at the very bottom of the plenum. The heater core is located in the plenum behind the stove core cover. The cover can be removed without removing the core of the plenum. Plenum meeting.
advertisement:
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.